Whether you’re moving into a new home or renovating your old home, it is important to think about the future. All of the electronic items in your home will require electricity to run. Your appliances, lights and HVAC unit all require electricity. If you’re not care, you’ll end up with an electricity bill that is simply too expensive. Therefore, you should think about these things, while renovating or moving. In this guide, you will learn at http://www.blueprintroofs.com about properly inspecting your heating and air conditioning unit. By properly following this guide, you will be able to ensure that your unit is working at maximum efficiency, which can help to decrease your monthly electric costs.
Turn it on
The first step is to approach your thermostat and turn on your unit. If you’re preparing for the summer, you will want to visit at angelosepoxyflooring.com. Otherwise, you will want to switch to the heating. Does the unit start right up? If the unit doesn’t kick on, you’ve definitely got a problem. Unless you’re good with electronics, you might want to leave this job to a professional company, such as GNR Corbus. Once the unit is up and running, you will want to head outside to that unit. Listen to the unit very closely. Do you hear anything that sounds bad? Does it sound like metal rubbing against metal? If you hear anything bad, you should shut off the unit immediately and contact a professional. If the unit sounds fine, you should proceed to the next step.
Heading to the Attic or Crawlspace
With the unit still running, you will want to head into the attic or crawlspace, whichever one holds your unit’s ductwork. Once you’ve found the duct, you will want to begin inspecting each line of duct. Since the unit is on, you should be able to locate leaks quite easily. Be sure to run your hands around the duct to check for leaks. If you happen to find a leak, you might be able to fix the problem with a little tape. If the leak is significant and too big for tape, you will likely need to replace the entire line, which would require the assistance of a professional. After all of the leaks have been fixed, you will want to head back to the thermostat and turn off the system.
Checking the Thermostat and Filter
When is the last time you have replaced the system’s filter? If you have a reusable filter, you will want to clean it very good, before putting it back. On the other hand, you might need a brand new one, if your filter isn’t reusable. When it comes to the thermostat, you will want to make sure that your equipment is up to date. New thermostats tend to be much more accurate than old ones. On the other hand, you will want to make sure that the thermostat has adequate power. If you have one that uses batteries, it is a good idea to put new batteries in it. Search at www.zigbee-automation-home.com for more tips.